HTTP API

The following documents the HTTP API of the thermostat / relay device. This was discovered by reading the original source code for the ESP8266 and using the dev tools in Firefox to inspect the calls in the web interface.

Note

This is incomplete, I will add more as I research it.

GET /control/thermostat.cgi?param=state

Get the status of the thermostat.

Parameters:

• param=state – Request state of the thermostat.

Example request:

GET /control/thermostat.cgi?param=state HTTP/1.1
Host: example.com
Accept: application/json, text/javascript

Example response:

HTTP/1.1 200 OK
Content-Type: application/json

{
 "temperature": "22.81",
 "humidity": "N/A",
 "humidistat": 0,
 "relay1state": 0,
 "relay1name":"Heating",
 "state":2,
 "manualsetpoint": 1900,
 "heat_cool":0
}

Status Codes:

• 200 OK – no error

POST /control/thermostat.cgi?param=thermostat_state

Set operation mode of the thermostat.

Parameters:

• param=thermostat_state – Set thermostat operation mode.

Form:

0 - off, 1 - schedule, 2 - manual

POST /control/thermostat.cgi?param=thermostat_manualsetpoint

Set target temperature of thermostat.

Form Parameters:

• int – Temperature in 1/100 C.

POST /control/thermostat.cgi?param=thermostat_heat_cool

Form:

0 - heating, 1 - cooling

POST /control/thermostat.cgi?param=thermostat_schedule

Set scheduled setpoint.

Example request:

POST /control/thermostat.cgi?param=thermostat_schedule HTTP/1.1
Accept: application/json

{"mon":
 [
  {"s": 0,
  "e": 2400,
  "sp": 2100
 ]
}

GET /control/relay.cgi?relay1=(int: state)

Change the current state of the relay.

Parameters:

• relay1 – 0 - off, 1 - on